DMARC with mailbox.org: what the provider specifies
In its knowledge base mailbox.org recommends publishing DMARC with p=none at first and always naming a rua address to which receivers send their reports. That address should be in the sending domain itself.
mailbox.org advises against the ruf tag for forensic reports: such reports contain parts of individual messages and, as mailbox.org puts it, are not permitted in Germany. The record itself is a TXT record at _dmarc at the DNS host; there is nothing to configure for it in the mailbox.org settings.
v=DMARC1; p=none; rua=mailto:postmaster@example.comHow to set up DMARC for mailbox.org
The procedure in four steps:
- Create and verify the SPF record and the four DKIM CNAMEs for mailbox.org.
- At the DNS host create a TXT record with the name _dmarc and the value above; use an address of your own domain as rua.
- Evaluate the incoming reports for a few weeks.
- Once every sender passes SPF or DKIM, tighten to p=quarantine and later p=reject.
Publishing at the DNS host
The DMARC record is a TXT record with the name _dmarc. It applies to the whole domain and every service sending on its behalf, not just the mail provider. The guides per host below show how to enter the name in the respective DNS editor.
Verify and keep an eye on it
The DMARC checker below reads the record, checks policy, reporting addresses and alignment and shows whether it matches SPF and DKIM of mailbox.org. DomainWarn keeps checking the record afterwards and alerts you when it changes or the policy is relaxed.